Hello everyone,
I start with a big thank you for all the work you provide on this project
I have a small question about the order of operations (Path).
In the picture attached as an example, "Edge_Profile" is first, but for machining, it must be last operation.
Is it possible to move "Edge_Profile" without redoing everything?
++
Order of operation
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
Order of operation
https://github.com/Xav83130/Mini-CNC
Tuto FR-basic -PATH - https://github.com/Xav83130/Mini-CNC/wi ... Basic-Path (plus a jour)
Tuto FR-basic -PATH - https://github.com/Xav83130/Mini-CNC/wi ... Basic-Path (plus a jour)
Re: Order of operation
In the job's General section you can change the sequence of execution.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Order of operation
Ok Chrisb it's good
Thx
Thx
https://github.com/Xav83130/Mini-CNC
Tuto FR-basic -PATH - https://github.com/Xav83130/Mini-CNC/wi ... Basic-Path (plus a jour)
Tuto FR-basic -PATH - https://github.com/Xav83130/Mini-CNC/wi ... Basic-Path (plus a jour)