[Bug] Part Design - Sweep

About the development of the Part Design module/workbench. PLEASE DO NOT POST HELP REQUESTS HERE!
Posts: 57
Joined: Thu Aug 07, 2014 8:50 am

[Bug] Part Design - Sweep

Postby Xav-83 » Wed Feb 15, 2017 6:06 pm

Good evening, wanting to make a "Sweep", in "part design", Freecad crash.
Better than words, a small video:

I also tested under linux, freecad crash too.

OS: Mac OS X
Word size of OS: 64-bit
Word size of FreeCAD: 64-bit
Version: 0.17.10085 (Git)
Build type: Release
Branch: (detached from 89925e2)
Hash: 89925e21a3a496fefd20aa47f9a974350330b0c9
Python version: 2.7.13
Qt version: 4.8.7
Coin version: 3.1.3
OCC version: 7.1.0
User avatar
Posts: 12279
Joined: Sat Feb 06, 2010 9:52 pm
Location: Québec, Canada

Re: [Bug] Part Design - Sweep

Postby NormandC » Thu Feb 16, 2017 4:10 am

This has been discussed a few times in the Help forum.

https://forum.freecadweb.org/viewtopic. ... 9&p=156267

And please read Bug submission guidelines

yorik wrote:2. If you are unsure, discuss the problem on the forum first. Open a new topic here on the forum, in the help section

(Although you are not the only one posting bugs in the development section and I wonder if the mods care anymore :roll: )

To my knowledge there has been no formal report on the tracker; we may have to wait though, the tracker has just been upgraded and there may be a few problems. https://forum.freecadweb.org/viewtopic.php?f=8&t=20699
Posts: 57
Joined: Thu Aug 07, 2014 8:50 am

Re: [Bug] Part Design - Sweep

Postby Xav-83 » Thu Feb 16, 2017 7:30 am

Ok NormandC, it is noted.
I searched but not enough. :roll:
Sorry for the duplicate.
A moderator can delete the post.