@ rockn - Nice. I haven't actually run any Gcode from FreeCAD on a machine yet, just in a simulator like OpenSCAM. Good to see it coming along.
I had a recent project, that while the model was quite simple, it did go through 3 versions in FreeCAD before a final design was decided on, dimensioned plans and templates were printed out, and the project was built. Almost finished except for the trim around the openings, (haven't found the right stuff yet), but still more than good enough for the little KittyMonster.
And where would ANY
FreeCAD project be it one did not include a few 3D printed parts?
And the almost finished project with intended benefactor. 3D printed parts are the green objects holding the rope that is wrapped around the dowels and hanging down for play.