[Sketshing] How can i link two points as one point ? [Problem is Fixed]

[superjamie]

Hey Designers...

I am an beginner with freeCAD and get this program sinds tuesday

I get an problem if i sketch an complex (or simple) part... the edges and points are not altimes linked as one stuck part...
If i want to fill my sketch... i got by complex sketches an error (no script error, but an error by fill my sketch), it said thad
the edges are not stuck to fill it...

I hope thad i can fix this problem if i can link two points as one point...

Can any one tell my how i can link two points as one point ?...
Thanks, Jamie van Cadsand...

[triplus]

it said thad
the edges are not stuck to fill it...

Well therefore you will have to "stuck" it.

P.S. If you need more help on how to achieve that please attach some images showing "un-stuck" edges first. And as this is your 3rd question in relatively short amount of time if you plan to "solve this one yourself" and will open another question please attach some images first showing the issue in that other thread.

[superjamie]

I think thad I can fix this problem with the red point (point on point) tool...
I want try this tomorrow... I have looked on the manual of freeCAD...

Greats, Jamie van Cadsand.

[triplus]

Yes, now that you have the manual i am sure you will be able to figure things out.

P.S. As for the trolling attempt i would give it 3 out of 10.

[superjamie]

Yes, now that you have the manual i am sure you will be able to figure things out.

P.S. As for the trolling attempt i would give it 3 out of 10.

This problem is fixed, i have it tested in freeCAD Program in the part design mode...
But thanks for your reactions.

[bejant]

the edges and points are not altimes linked as one stuck part.

Hi, as you've discovered, in Sketcher two or more points are not exactly the same until the Coincident Constraint is applied to them.

i got by complex sketches an error (no script error, but an error by fill my sketch)

You can see error messages and other things happening inside FreeCAD by going to Edit (pull-down menu) > Preferences > General (icon in left pane) > Output window (tab at top of right pane) and ticking the two "Redirect internal Python..." tick-boxes to True and click the Ok button. Then go to the View pull-down menu > Panels and tick "Report View and "Python console" to True.