Cyber3DK wrote:Could you please "report this up the chain"
I think chrisb is correct, this is not a bug.
The solver will identify the conflict when it is clear. For example, trying to place a single point (line end, circle origin, etc.) at two different locations will be readily identified.
However, in the case you created it is not automatically clear even to a human where the conflict arises. Perhaps the angle constraint is the problem, or perhaps the line length constraint is the problem. In that case the solver just says, "I cannot find a solution."
There are many cases in which multiple horizontal and vertical constraints peacefully coexist in a sketch, so there is really no good basis for the sketcher to determine where the failure to solve fault might lie.
By the way, it is not necessary to look in the report view simply for the notification. The main sketcher display says "unsolved" up at the top. The detail, if any, is found in the report view.
/minor rant on/
The sketcher may be the most widely used workbench in FreeCAD. There are always bugs in any software, and there are always missing features. However, it is not very likely that you or anyone else will immediately find so many new bugs in the very basic features that are used thousands of times per day.
/minor rant off/