Surface extension / merging

Post here for help on using FreeCAD's graphical user interface (GUI).
Forum rules
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help

Also, be nice to others! Read the FreeCAD code of conduct!
Post Reply
monte0682
Posts: 5
Joined: Fri Mar 17, 2017 11:37 am

Surface extension / merging

Post by monte0682 »

Hello,

I have two surfaces which have a small gap between. I need them to be joined. I need this for FEM. How this can be done? I was thinking to extend surfaces and then do Boolean operation to cut at intersection.

Or I created a small missing surface between, but I do not know how to join it to the other surfaces, as when I mesh I will gt bad elements since the surface is very small.

Thank you very much.
Attachments
Capture.PNG
Capture.PNG (9.83 KiB) Viewed 643 times
Post Reply