Surface extension / merging

Post here for help on using FreeCAD's graphical user interface (GUI).
Posts: 1
Joined: Fri Mar 17, 2017 11:37 am

Surface extension / merging

Postby monte0682 » Fri Mar 17, 2017 11:46 am


I have two surfaces which have a small gap between. I need them to be joined. I need this for FEM. How this can be done? I was thinking to extend surfaces and then do Boolean operation to cut at intersection.

Or I created a small missing surface between, but I do not know how to join it to the other surfaces, as when I mesh I will gt bad elements since the surface is very small.

Thank you very much.
Capture.PNG (9.83 KiB) Viewed 95 times