Offset
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Offset
Hello I had a solid object. I downgraded to faces, when wires and edges. I wanted to change this profile and extrude again. However, I can not do anything with edges, such as trim, offset...etc. You can see the attachment. I want to create a radius between two line at the end. Can you suggest how this can be done?
- Attachments
-
- Capture.PNG (26.22 KiB) Viewed 645 times
Re: Offset
Hi,
Make a sketch of your profile.
2 solutions :
1st solution draw the sketch from scratch and extrude it
2nd Solution, use the Draft_Upgrade tool to come back to a single wire from your edges. then use Draft_Draft2Sketch tool to convert this wire to sketch, then you can apply the constraints you want and modify your profil.
I don't know if it is possible only with Draft WB, as I am a sketcher guy
Make a sketch of your profile.
2 solutions :
1st solution draw the sketch from scratch and extrude it
2nd Solution, use the Draft_Upgrade tool to come back to a single wire from your edges. then use Draft_Draft2Sketch tool to convert this wire to sketch, then you can apply the constraints you want and modify your profil.
I don't know if it is possible only with Draft WB, as I am a sketcher guy
-
freecad-heini-1
- Veteran
- Posts: 7790
- Joined: Tue Jan 07, 2014 11:10 am
- Contact:
Re: Offset
Please check our my freecad model.
Change the dimensions as needed.
Change the dimensions as needed.