I did try to read the "before your post here" thread and tried to follow it as much as I could
Thank you very much for the help and the explanation, I really appreciate the opportunity to explain where I am going wrong and best practices. as I mentioned I am new to 3D design in general and your pointers are really valuable to me in my learning phase.
I have looked at the sketch you sent (really appreciate it - again-
) and I see your points on the dimensional constrains, I knew from the looks of it being so missy that there should be a better way, and I can see it now from your sketch. for the tangent constrains, I deleted most of these when I got conflict messages during the trial and error process I was going through, and I totally see your point.
I am really glad I got my way to using freeCAD based on the response I got here, I like being in community where help is offered this quickly and thoroughly like your answer.