Assembly Workbench icons aligned to guidelines

A subforum for research and development of the user interface of FreeCAD

Moderator: agryson

User avatar
agryson
Posts: 442
Joined: Wed Nov 23, 2016 8:30 am
Location: Paris, France
Contact:

Re: Assembly Workbench icons aligned to guidelines

Postby agryson » Sun Mar 19, 2017 9:19 pm

triplus
Posts: 4852
Joined: Mon Dec 12, 2011 4:45 pm

Re: Assembly Workbench icons aligned to guidelines

Postby triplus » Mon Mar 20, 2017 1:02 am

agryson wrote:Done.
Thanks for the tip on implementation @triplus

This can now be in the pull request. (tested sucessfully on local)

AssemblyWorkbench.svg


You're welcome. I guess what we now need is a bit more useful Assembly workbench. ;)

P.S. Or maybe after you finish all the work you might give it a shot at aligning Assembly 2 workbench icons. As that is more or less what FreeCAD users have been using in the past years when it comes to Assembly capabilities. Note that this is just an idea and feel free to disregard it.
User avatar
agryson
Posts: 442
Joined: Wed Nov 23, 2016 8:30 am
Location: Paris, France
Contact:

Re: Assembly Workbench icons aligned to guidelines

Postby agryson » Mon Mar 20, 2017 5:57 am

triplus wrote:maybe after you finish all the work you might give it a shot at aligning Assembly 2 workbench icons. As that is more or less what FreeCAD users have been using in the past years
sounds good, and I'm sure that many of the icons could be reused between the two during development of FreeCAD Assembly. added to the list