Assembly Workbench icons aligned to guidelines

A forum for research and development of the user interface of FreeCAD
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
User avatar
agryson
Posts: 463
Joined: Wed Nov 23, 2016 8:30 am
Location: Bordeaux, France
Contact:

Re: Assembly Workbench icons aligned to guidelines

Post by agryson »

triplus
Veteran
Posts: 9471
Joined: Mon Dec 12, 2011 4:45 pm

Re: Assembly Workbench icons aligned to guidelines

Post by triplus »

agryson wrote:Done.
Thanks for the tip on implementation @triplus

This can now be in the pull request. (tested sucessfully on local)

AssemblyWorkbench.svg
You're welcome. I guess what we now need is a bit more useful Assembly workbench. ;)

P.S. Or maybe after you finish all the work you might give it a shot at aligning Assembly 2 workbench icons. As that is more or less what FreeCAD users have been using in the past years when it comes to Assembly capabilities. Note that this is just an idea and feel free to disregard it.
User avatar
agryson
Posts: 463
Joined: Wed Nov 23, 2016 8:30 am
Location: Bordeaux, France
Contact:

Re: Assembly Workbench icons aligned to guidelines

Post by agryson »

triplus wrote:maybe after you finish all the work you might give it a shot at aligning Assembly 2 workbench icons. As that is more or less what FreeCAD users have been using in the past years
sounds good, and I'm sure that many of the icons could be reused between the two during development of FreeCAD Assembly. added to the list
Post Reply