Hi,
some observations:
1) Wireframe view is very poor. Most of lines are not visible why is that, will it be improved? Wireframe view is important meanwhile 2d drawing - later in point 2.
2) While creating new drawing everything should go straight into wireframe view mode or all other objects should be very transparent. It is hard to sketch when everything is covered by solids.
3) There should be a key assigned to selection in that way, when one solid/planes is covering other one then by holding pressed for example "tab" button you will be able to select item behind.
What do you think?
Views and selection
Forum rules
Be nice to others! Read the FreeCAD code of conduct!
Be nice to others! Read the FreeCAD code of conduct!
Re: Views and selection
Post was dig in but questions are still valid
4) Is there any way to check degrees of freedom of assembly in freecad? If not, will that be added?
4) Is there any way to check degrees of freedom of assembly in freecad? If not, will that be added?
- microelly2
- Veteran
- Posts: 4688
- Joined: Tue Nov 12, 2013 4:06 pm
- Contact:
Re: Views and selection
https://www.youtube.com/watch?v=Dsq2IvSeruoefyx wrote: 3) There should be a key assigned to selection in that way, when one solid/planes is covering other one then by holding pressed for example "tab" button you will be able to select item behind.
What do you think?