Search found 5 matches
- Wed Jun 14, 2017 6:58 pm
- Forum: Help on using FreeCAD
- Topic: Arch CutPlane - Error: tuple index out of range
- Replies: 17
- Views: 4197
Re: Arch CutPlane - Error: tuple index out of range
dear bejant I can try, if you like. Thank you, maybe next time I have an urgent need for it, obviously unless it has been resolved in the mean time. Maybe someone with a 64 bit version of FreeCAD will try too and we can compare results to see if it is a problem on all 64 bit versions or maybe someth...
- Wed Jun 14, 2017 12:08 pm
- Forum: Help on using FreeCAD
- Topic: Arch CutPlane - Error: tuple index out of range
- Replies: 17
- Views: 4197
Re: Arch CutPlane - Error: tuple index out of range
Dear bejant it works as expected for me So can I send my drawing to you, so you can make a CutPlane for me? :D Seriously, it's not working even with just a solid cylinder and a rectangle. I guess I will have to make a new install of FreeCAD, I see you are using a 32 bit version, whereas I'm using a ...
- Wed Jun 14, 2017 11:09 am
- Forum: Help on using FreeCAD
- Topic: Arch CutPlane - Error: tuple index out of range
- Replies: 17
- Views: 4197
Arch CutPlane - Error: tuple index out of range
Hello Experts, I have a slight problem with Arch CutPlane, I just wasted 4 hours getting it to work, but to no avail. In the attached drawing, when I select in the following order "axle" then "Rectangle001", and follow the instructions here https://www.freecadweb.org/wiki/Arch_Cu...
- Tue Feb 28, 2017 9:28 am
- Forum: Help on using FreeCAD
- Topic: How to create a skewed cone?
- Replies: 3
- Views: 1136
Re: How to create a skewed cone?
Thank you, it seemed to do the trick. Except there is a thin slit in the surface from top to bottom of the cone, I'm not sure whether thats a rendering error or not.DeepSOIC wrote:Create the circles for bases using whatever method you like (e.g., two sketches). And then Part Loft across them.
- Mon Feb 27, 2017 9:32 pm
- Forum: Help on using FreeCAD
- Topic: How to create a skewed cone?
- Replies: 3
- Views: 1136
How to create a skewed cone?
Hello! I want to create a skewed cone. In part work bench you can create a solid cone, and it has Radius1, Radius2 and Height. My problem is that the center of Radius1 and Radius2 is on the same plane, but I would like the center of Radius1 to be off center, how do I do that? Thank you in advance. O...