Search found 4 matches

Go to advanced search

by filipp.sudanov
Fri May 11, 2018 5:34 pm
Forum: Path/CAM
Topic: rml containing curves runs incorrectly on Roland MDX-40A
Replies: 2
Views: 301

rml containing curves runs incorrectly on Roland MDX-40A

I am trying to use freecad path module with rml postprocessor with Roland MDX-40. When there is no curves in generated code, it runs fine, but for program with curves instead of performing the curve Z axis goes up to the maximum and then goes back down to run the next straight piece of program. Here...
by filipp.sudanov
Tue Dec 12, 2017 5:59 pm
Forum: Path/CAM
Topic: Incorrect path orientation, when path created from rotated sketch
Replies: 17
Views: 931

Re: Incorrect path orientation, when path created from rotated sketch

So, regardless if you changed the Placement of your Part, you can modify the Placement of the Base-object clone at any time to suit your needs. You can do that manually in the property editor, use any tools from the Draft WB or the minimal tools we created in the Job editor. In the Setup tab the bu...
by filipp.sudanov
Tue Dec 12, 2017 5:44 pm
Forum: Path/CAM
Topic: Incorrect path orientation, when path created from rotated sketch
Replies: 17
Views: 931

Re: Incorrect path orientation, when path created from rotated sketch

chrisb wrote:
Sun Dec 10, 2017 6:44 am
The model has probably been created in 0.16.
Actually, the original model was created in 0.15 (Version: 0.15.4671 (Git)) - the stable version from Ubuntu repos. Then imported into 0.17 for path creation.
by filipp.sudanov
Fri Dec 08, 2017 7:39 pm
Forum: Path/CAM
Topic: Incorrect path orientation, when path created from rotated sketch
Replies: 17
Views: 931

Incorrect path orientation, when path created from rotated sketch

I've made two sketches, two pads out of them and created paths from these pads. Both sketches have 90 degree rotation in their placement properties. Paths for one pad are correct, but for another the path does not take the rotation angle for the sketch into account. Freecad document attached. freeca...

Go to advanced search