Search found 4 matches
- Fri May 11, 2018 5:34 pm
- Forum: Path/CAM
- Topic: rml containing curves runs incorrectly on Roland MDX-40A
- Replies: 2
- Views: 989
rml containing curves runs incorrectly on Roland MDX-40A
I am trying to use freecad path module with rml postprocessor with Roland MDX-40. When there is no curves in generated code, it runs fine, but for program with curves instead of performing the curve Z axis goes up to the maximum and then goes back down to run the next straight piece of program. Here...
- Tue Dec 12, 2017 5:59 pm
- Forum: Path/CAM
- Topic: Incorrect path orientation, when path created from rotated sketch
- Replies: 17
- Views: 2343
Re: Incorrect path orientation, when path created from rotated sketch
So, regardless if you changed the Placement of your Part, you can modify the Placement of the Base-object clone at any time to suit your needs. You can do that manually in the property editor, use any tools from the Draft WB or the minimal tools we created in the Job editor. In the Setup tab the bu...
- Tue Dec 12, 2017 5:44 pm
- Forum: Path/CAM
- Topic: Incorrect path orientation, when path created from rotated sketch
- Replies: 17
- Views: 2343
- Fri Dec 08, 2017 7:39 pm
- Forum: Path/CAM
- Topic: Incorrect path orientation, when path created from rotated sketch
- Replies: 17
- Views: 2343
Incorrect path orientation, when path created from rotated sketch
I've made two sketches, two pads out of them and created paths from these pads. Both sketches have 90 degree rotation in their placement properties. Paths for one pad are correct, but for another the path does not take the rotation angle for the sketch into account. Freecad document attached. freeca...