"TEE" junctions are not allowed for PD sketches.
Trim the lines next to the circles.....
Search found 4266 matches
- Tue Apr 23, 2024 12:18 pm
- Forum: Help on using FreeCAD
- Topic: Sketch fully constrained, but still not
- Replies: 3
- Views: 80
- Tue Apr 23, 2024 10:26 am
- Forum: Help on using FreeCAD
- Topic: Joining two cylinders at an angle
- Replies: 7
- Views: 335
Re: Joining two cylinders at an angle
Part joint connect.
- Tue Apr 23, 2024 6:11 am
- Forum: Draft, Arch & BIM
- Topic: Snap for the draft workspace
- Replies: 10
- Views: 295
Re: Snap for the draft workspace
You have snap grid enabled also. Only use the required snap tools for any one job.......
- Tue Apr 23, 2024 6:05 am
- Forum: Help on using FreeCAD
- Topic: Cant get my FreeCAD design to print on Xmax3 with Orca slicer PLEASE HELP
- Replies: 9
- Views: 372
Re: Cant get my FreeCAD design to print on Xmax3 with Orca slicer PLEASE HELP
Don't get frustrated here, this sounds like a Printer/slicer problem, use another forum.
- Mon Apr 22, 2024 10:56 am
- Forum: Help on using FreeCAD
- Topic: LCS not at centre of Sphere
- Replies: 5
- Views: 290
- Mon Apr 22, 2024 9:46 am
- Forum: Help on using FreeCAD
- Topic: LCS not at centre of Sphere
- Replies: 5
- Views: 290
Re: LCS not at centre of Sphere
Attach it to the sketch for that pocket, mode concentric.....
- Sun Apr 21, 2024 4:39 pm
- Forum: Help on using FreeCAD
- Topic: Linear Pattern: Part design _ transformed shapes do not intersect support
- Replies: 3
- Views: 257
Re: Linear Pattern: Part design _ transformed shapes do not intersect support
If the pillars have to be separate bodies, then use a draft array instead of a PD pattern.
- Sun Apr 21, 2024 1:10 pm
- Forum: Help on using FreeCAD
- Topic: Linear Pattern: Part design _ transformed shapes do not intersect support
- Replies: 3
- Views: 257
Re: Linear Pattern: Part design _ transformed shapes do not intersect support
Single solid rule, you have to add the pillars to the pattern so it will succeed.
- Sun Apr 21, 2024 12:54 pm
- Forum: Open discussion
- Topic: [Solved] Missing "Selecting" button in Mirror function (Part)
- Replies: 7
- Views: 325
Re: Missing "Selecting" button in Mirror function (Part)
Perhaps I wasn't clear, it is only available in the dev version (FC 0.22)
- Sun Apr 21, 2024 11:45 am
- Forum: Open discussion
- Topic: [Solved] Missing "Selecting" button in Mirror function (Part)
- Replies: 7
- Views: 325
Re: Missing "Selecting" button in Mirror function (Part)
It's not available in your version upgrade.