I am thinking now that I should have deleted the extra refine pockets that are causing the red arrows in Dependency Graph. Then delete the pocket that was not showing in the model then redo the pocket. Hopefully this will make a clean Dependency Graph. DEP_GRAPH_REPAIR_09.png Just redid the refine s...

want to add that I rate bejant's videos very high! Thanks, but I consider them obsolete now (if I could log into my YouTube account I'd probably delete them). I think part of my problem in doing video 09 is that different versions were being used resulting in different tree views. So I could not co...

Are you saying it should be deleted Yes, delete that horizontal constraint. May I ask why you want confirmation for that? You could test it yourself and see that after deletion the sketch is still fully constrained. because this contradicts the video. The constraint was still there when the sketch ...

about at minute 17:10 in the video a new sketch is made on the face of the 2nd pad the video selects the edge of the hole in the pad and clicks "make a link to external geometry" then makes a circle establishing its center at the center of the hole. apparently that made a coincidence between the cen...

if you check video tutorial 09 made by bejant, there is a horizontal constraint on the short line segment. Are you saying I should delete this? No, there is a symmetry constraint at the top of the sketch. That has an additional horizontal constraint. Yes, at minute 11:14 you can see the symmetry co...

I told you in my previous post what to do to fully constrain the sketch. See above. You applied the tangency only at one end of the arc. Yes, I realized that I had confused the "fix point to object" with "tangency" because they look similar. I removed both constraints (1. coincidence and 2. fix poi...

Use tangents at the endpoints of the marked arc instead of coincidence. Furthermore you should again(!) delete the automatically generated horizontal constraint which is implied by the symmetry. As you know vid 09 puts in the horizontal constraint before the small arc is attached to the larger. The...

OS: Linux Mint 18.3 Sylvia Word size of OS: 64-bit Word size of FreeCAD: 64-bit Version: 0.17.13522 (Git) Build type: None Branch: releases/FreeCAD-0-17 Hash: 3bb5ff4e70c0c526f2d9dd69b1004155b2f527f2 Python version: 2.7.12 Qt version: 4.8.7 Coin version: 4.0.0a OCC version: 7.2.0 Locale: English/Uni...

If you don't mind I will start a new thread since I am in video tutorial 09 now.

The two different ways to model a Switch Base shouldn't be difficult because the Switch Base is a single piece. If you start the model by creating your very first Sketch while you are in the Part Design WB, a Body should automatically be created and made active before you are taken to the Sketcher ...