Search found 263 matches

Go to advanced search

by kwahoo
Fri Dec 06, 2013 2:32 pm
Forum: Assembly
Topic: Test request
Replies: 78
Views: 19523

Re: Test request

Hello kawahoo, thanks for the file, I will have a look. When i find time... No problem, I can wait;) What I would do is first export the crank bracket to .step then start over from scratch. First with the piston, then pin, connecting rod, crank, crank bracket, rod cap and finish off with the c-clip...
by kwahoo
Tue Dec 03, 2013 6:03 pm
Forum: Announcements & Features
Topic: Forum migration
Replies: 180
Views: 29497

Re: Forum migration

yorik wrote:The problem was that new users are added to both "new registered users" and "registered users". Only after they have 1 post approved, they are removed from the "new registered users".
Is this policy still active? My first posts on the new forum never passed moderation...
by kwahoo
Mon Dec 02, 2013 10:52 pm
Forum: Assembly
Topic: Test request
Replies: 78
Views: 19523

Re: Test request

Hello all, so, there is my problem. I need a coincidence between the piston hole and the conrod hole - as highlighted. I applied coincidence between liner (invisible in the picture) and piston surface before. Unfortunately FreeCAD is freezes and everything vanishes when the "piston-conrod" constrain...

Go to advanced search