just found that for multiple arrays or clones thereof there needs to be an additional patch around line 276: # Find the center of mass depending of the type of object. if hasattr(objs[sol], "CenterOfMass"): self.centerofmasses[sol] = objs[sol].CenterOfMass elif hasattr(objs[sol], "Sol...

Around line 300 this patch seems to work. But i'am not 100% certain. May be a professional could have a closer look at it. #2: an array is selected if hasattr(sel[sol], 'ArrayType'): if sel[sol].ArrayType == 'polar' and sel[sol].NumberPolar > 0: # self.centerofmasses[sol] = sel[sol].Center self.cent...

Thanks for this macro and i'am using it currently to get the COM of my VIIC. Two issues i did find though but maybe it is just me beeing to much oldschool and not OO compatible ... 1) There might be a bug within the polar array calculation. The macro does not step through the solids in the array but...

Deck cutting took about 4.5hours overall for 1mm finnboard. You might want to add max 10% spirit (ethyl alcohol; "Spiritus") to your resin. This ensures that the resin will not harden rock solid. The deck will be held in place by neodyn magnets. 15W Laser: Speed 500mm/min , 2 passes, Light...

Deck and canon tower with some details for eye candy. Materials used: finnboard, drawing board, DIY birch plywood (1.8mm), 0.6mm beech veneer, brass tube and wire, alu tube, electronic solder, resin, watertight glue. Finish will be matt clear paint. No coloring intended. Pls note the latest swiss ma...

Conning tower platform cut from DIY plywood. May be the matrial to go also for the deck.

Deck Layout (Directors Cut). First test sheets, on the right, resined and ok. Material will be 1mm Finnboard. But i do have to re-tyre my laser cutter. We do have a disagreement about "linear" or "straight". If that won't help i need to design me own one with linear bearings and ...

Sharky shows its teeth ... on to the technical stuff. Hull will be beautified when everything else is in working conditions. Deck drawing for laser finished. Not sure which material to take. Maybe 1mm Balsa so i can encarve the planks and so on.

Aft section with inlet build in. What is really cool is that the opening of the aft inlet do fall in line with the frames of the hull. Same should happen for the front body section. Adds some visual spice for close up looking. First sketch of the deck loosely attached to clarify sectioning and fix p...

ahh, these front,back,under,down confusion. Frankly i'am too stupid to make my mind up "do i look down on top of the paper, or do i sit in front of the paper ..." . Sure recipe to drive me nuts. Personally i prefer +X,+Y,+Z .... -Z viewing directions. But that's only me, who had been condi...