That's good info Gene on the pitch approximation--much appreciated. Hand coding is fine too Because Path-WB shows paths for Custom GCode, there is still a lot the software is bringing to the table still. Hand also coding allows me to slave the XY motion to the Z-axis.
Have you threaded with a Thread-Mill Gene? You touched on offset since cutting edge doesn't extend to the end of the Tool. I believe I'm ok if I account for the offset and limit how deep I travel....... but I'm always open to the advise of someone more experienced...
Best,
Josh
Couple of potential bugs...
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!