Works perfect here.
- Did you leave the simulation mode with Cancel or with Ok?
- If it's Ok there will be some residues "Cut material"; delete them.
- Did you select the Job for simulation or something else?
Reusable Nameplate Drawing
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
Re: Reusable Nameplate Drawing
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
-
- Posts: 78
- Joined: Fri May 11, 2018 9:28 am
Re: Reusable Nameplate Drawing
I've tried a few variations. This time I opened shapeString-cb2, clicked on ShapeString, added another x to make the string 'More Textx', recalculate everything, selected Job and simulate. It doesn't simulate.
Re: Reusable Nameplate Drawing
You need the current development version,which you can install in parallel to your stable version. The dev version seems currently to be very stable as well.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
-
- Posts: 78
- Joined: Fri May 11, 2018 9:28 am
Re: Reusable Nameplate Drawing
Just downloaded and installed the AppImage for v18 and repeated the test. Works perfectly!
I will continue to use v18 and continue my quest to master FreeCAD
Many thanks again
Mick
I will continue to use v18 and continue my quest to master FreeCAD
Many thanks again
Mick
Re: Reusable Nameplate Drawing
Glad to hear it works.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.