Won't generate G code

Routerworks · Post by **Routerworks** » Wed Oct 03, 2018 3:10 pm

Darn. I forgot that. I changed it and it worked in the old version.
Is there a list of commands like that?

Thanks again

Post by **GeneFC** » Wed Oct 03, 2018 3:51 pm

I believe all the valid "--" commands show up when you hover over the Arguments box in the Output tab of the Job setup panels.

Gene

Routerworks · Post by **Routerworks** » Thu Oct 04, 2018 12:26 am

When I hover over it all it seems to say is "arguments for the post processor (specific to the scripts).

Thanks

Post by **chrisb** » Thu Oct 04, 2018 4:54 am

Double click on the job, go to the Output tab, and hover over the Arguments field.

mlampert · Post by **mlampert** » Thu Oct 04, 2018 6:30 am

if you don't have a post processor selected the tooltip is generic - once a post processor is selected the tooltip should be specific for the post processor (assuming the post processor provides a tooltip which is true for all stock post processors).

Routerworks · Post by **Routerworks** » Thu Oct 04, 2018 4:00 pm

Found the post processor commands. Thanks
Version 0.18 seems to be working quite well.

Getting there.

Thanks again.

Won't generate G code

Re: Won't generate G code

Re: Won't generate G code

Re: Won't generate G code

Re: Won't generate G code

Re: Won't generate G code

Re: Won't generate G code