How to engrave a line?

Here's the place for discussion related to CAM/CNC and the development of the Path module.
micksulley
Posts: 78
Joined: Fri May 11, 2018 9:28 am

Re: How to engrave a line?

Postby micksulley » Thu Oct 25, 2018 8:52 pm

I am seeing some strange behaviour here. Attached is my current file, some additional operations but it is the PathShape which looks strange.
Just playing with Z on SketchEngraveLines, I can change Z in Attachment but not in Base. If I change Z in Attachment then Z Base changes, but not by the same amount, except that if I change it to zero then Z Base does not change. The g-code Z seems to be the difference between the two.
I assume that this is a bug, or have I missed something.

This is not a show stopper for me, I can fairly easily reset Z on my machine to compensate.

Thanks
Mick
Attachments
RJ45x7v5.fcstd
(55.73 KiB) Downloaded 8 times
chrisb
Posts: 18784
Joined: Tue Mar 17, 2015 9:14 am

Re: How to engrave a line?

Postby chrisb » Thu Oct 25, 2018 9:18 pm

Please go back in this topic and read carefully what has been said before. mlampert has mentioned a cyclic dependency, and I have shown how to remove it and uploaded a corrected model.
If you decide to continue with your erroneous model you will get these strange results.

Inside of a body you can only change the attachment offset. This adds to the placement of the attachment plane.