path workbench

[tani]

Hello;

I have a problem about path workbench. Problem is:

I created a cone and measures as follows

Radius 1 = 10,00 mm
Radius 2 = 4 mm
Height= 10,00 mm

I work with facing operation and use 4 mm wide ball end milll as a tool. But ı can't get a conical motion in simulation on workbench.

It is move down in the same plane. What is the reason? Can you help me please?

[chrisb]

Moved to Path subforum.

[RatonLaveur]

Hello tani,

Could you please send your freecad info (help, about freecad, copy to clipboard)

And a copy of your file so we can start to help you?

[chrisb]

A cone sounds as if you should use 3D pocket (with an additional plate at the bottom as support or 3D surface (experimental operation).

[tani]

Moved to Path subforum.

thanks, ı solve that problem.

[tani]

A cone sounds as if you should use 3D pocket (with an additional plate at the bottom as support or 3D surface (experimental operation).

thanks;

ı solved that problem

[tani]

Hello tani,

Could you please send your freecad info (help, about freecad, copy to clipboard)

And a copy of your file so we can start to help you?

thanks;

ı solved that problem