Spiral pattern - for what?
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
-
- Posts: 541
- Joined: Fri Aug 26, 2016 9:07 pm
- Location: Munich - Gemany
Re: Spiral pattern - for what?
Should I have to report this bug somewhere?
Re: Spiral pattern - for what?
I can confirm the toolpath is wrong for this, I just had the same issue some time ago.
Depending on the material which you want to cut, you might try to use the adaptive toolpath for now. Certainly it will be slower due to more air-cuts.
Depending on the material which you want to cut, you might try to use the adaptive toolpath for now. Certainly it will be slower due to more air-cuts.
Re: Spiral pattern - for what?
This problem has been known for quite some time, I've reported on it. Perhaps PR#4965 solves it.
https://forum.freecadweb.org/viewtopic.php?f=15&t=61146
https://forum.freecadweb.org/viewtopic.php?f=15&t=61146