I think we need this for every operation
I was doing an adaptive clearing face for a rather complex model of a small PCB and with a 0.5mm mill and 75%steopver with the A/P slider cranked all the way to the right it succesfully generated the toolpath for the entire face in about 6 minutes or so ... then it just halted completley after it was done.
you know how you can still move around the viewport while an adaptive is generating and you can also stop it with the [STOP] button at the bottom (also fun fact if you click the cancel at the top while it's generating it will delete the adaptive operation but it will keep generating anyway lol
but after the path itself is done ... as it gets "converted from blue to green" during that phase it's completley impossible to stop and I like left it there for 30 minutes and nothing happened so it's pretty safe to say it halted (i'm using a ROG Strix G).
also fun fact if I try to do a pocket face on it it halts immediatley after I press the button.