Pocket Contour Cutting Help (using Path WB)

Here's the place for discussion related to CAM/CNC and the development of the Path module.
jmaustpc
Posts: 9991
Joined: Tue Jul 26, 2011 6:28 am
Location: Australia

Re: Pocket Contour Cutting Help (using Path WB)

Postby jmaustpc » Thu Aug 06, 2020 8:38 am

taddytoo wrote:
Wed Aug 05, 2020 8:18 pm
When i tried to select the inside paths of the inside of the Y, E, and S, it would just select a little part and not the entire thing, Is there a simple way to select that entire path so that I can turn it into a profile contour?
You have asked about and been answered regarding this specific matter in Path WB, however I just thought I would add that in general all over FreeCAD you can "multi-select" by holding the Ctrl key down while selecting multiple things and then all items clicked on will be selected. On Apple you would use a different key or key combination.