Colleagues, long ago I was going to write about it, but the evil google captcha (google hates me) prevented entry.
There is no solution to the error in creating a Pocket operation with ofset & spiral strategies.
Ofset in the center does something unnecessary.
Spiral only handles the edges.
In all cases, when trying to set the allowance with a negative value (usually from minus 2) everything dies. And such an allowance is needed as a preparatory operation for the following operations.
Zig-zag allows negative allowance (of the required size), but because of the constant change of directions the time of operation by zig-zag method in large areas is much longer than (speculatively and in practice, too) offset or spiral (because of the need for constant stops and change of direction in zig-zag).
OS: Arch Linux (GNOME/gnome-xorg)
Word size of FreeCAD: 64-bit
Version: 0.20.25352 (Git) AppImage
Build type: Release
Branch: master
Hash: 29c6f96ad41bfddf6ea86925a81d22fb24de44d0
Python version: 3.9.6
Qt version: 5.12.9
Coin version: 4.0.0
OCC version: 7.5.2
Locale: Russian/Russia (ru_RU)
Ofset in the center does something unnecessary.
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
Ofset in the center does something unnecessary.
- Attachments
-
- ofset.FCStd
- (30.64 KiB) Downloaded 32 times
-
- Снимок экрана от 2021-08-07 18-23-18.png (212.11 KiB) Viewed 1495 times
-
- Снимок экрана от 2021-08-07 18-23-35.png (184.72 KiB) Viewed 1495 times
-
- Снимок экрана от 2021-08-07 18-23-58.png (157.94 KiB) Viewed 1495 times