I would like to mill a workpiece from two sides.
For this I followed the very good tutorial from sliptonic on YouTube (https://www.youtube.com/watch?v=QjlfL5IQxzI). By the way, many, many thanks for this great introduction!
To show the problem in a concentrated way I have created the following example project: The job bottom now needs an inversion of the Z-axis. What is the easiest way to do this?
- Via the setup of the job?
- Via the transformation of the associated model? Unfortunately, the function "Transform" to the model does not work.
- Is there a simple workaround via the placement parameters in the base of the model?
With best regards
Arne