Enter FreeCAD 1.0 development cycle

Post here if you have re-based and finalised code to integrate into master, which was discussed, agreed to and tested in other forums. You can also submit your PR directly on github.
openBrain
Posts: 5213
Joined: Fri Nov 09, 2018 5:38 pm

Re: Enter FreeCAD 1.0 development cycle

Postby openBrain » Thu Jun 04, 2020 3:35 pm

This is what the "Pull Requests" subforum is made for :
Post here if you have re-based and finalised code to integrate into master, which was discussed, agreed to and tested in other forums. You can also submit your PR directly on github.
Do you think this topic matches ? And seriously, do you think this topic was needed ?
Last but not least : FreeCAD is already in its 1.0 dev cycle. When 1.0 will be released, it will mean FC enters its 2.0 dev cycle...