normandc wrote: Also, does this tool work on edges?
Hi Norm, I took a while to answer that, I had to experiment.
It used to do so in 0.13, I don't know if it is still doing so in 0.14 or not, because the Part Ruled Surface tool has changed its behaviour. The picture shows what 0.13 used to do, but now 0.14 seems to automatically work out which vertex is the best to link to which other vertex.
This below is what it looks like in 0.13 if one line is reversed and you use Part Ruled Surface
this is the same file as above in 0.14Dev from today, at first it opens the file the same as 0.13 but then if you force a recompute by adjusting a parameter it changes it to what it would do if you had just used Part Ruled Surface in 0.14dev.
then if you open the file again in 0.13 it looks as you saved it in 0.14...once again if you recompute it goes back to twisted shape as 0.13 first made.