OOFem

About the development of the FEM module/workbench.

Moderator: bernd

User avatar
HarryvL
Posts: 577
Joined: Sat Jan 06, 2018 7:38 pm
Location: Denmark

Re: OOFem

Postby HarryvL » Fri Nov 02, 2018 2:04 pm

bernd wrote:
Thu Nov 01, 2018 5:10 pm
They will be assigned if needed ...

For example for the CalculiX mesh they are not needed. Thus for calculix they are only needed for constraints like force or pressure, thus they are assigned inside each constraint writer. For example on calculix frequency analysis without constraints they are not needed at all. Z88 needs them for mesh writing too. Means they are needed for any input file writing. Thus they are assigned just at start of writing. They are assigned here: https://github.com/HarryvL/FreeCAD/blob ... py#L66-L69

Means for oofem your would copy the lines from above to https://github.com/HarryvL/FreeCAD/blob ... ter.py#L75 if you need them in any file write (which will be true if you need them for mesh writing).

hope that helps bernd
Fantastic. That worked.
User avatar
bernd
Posts: 6300
Joined: Sun Sep 08, 2013 8:07 pm
Location: Zürich, Switzerland

Re: OOFem

Postby bernd » Fri Nov 02, 2018 4:22 pm

8-)
User avatar
Kunda1
Posts: 3247
Joined: Thu Jan 05, 2017 9:03 pm

Re: OOFem

Postby Kunda1 » Fri Nov 09, 2018 1:05 am

This thread was mentioned in bernd's roadmap thread: https://forum.freecadweb.org/viewtopic.php?f=18&t=32126
Want to contribute back to FC? Checkout:
#lowhangingfruit | Use the Source, Luke. | How to Help FreeCAD | How to report FC bugs and features