No not for the warp. I just changed the scale values. They should get some smarter prev values. If you would like to use the FEM clipping plane with VTK post processing you need the latest fix which is in a PR ATM.
The reason I'm asking in some rare cases it did not work for me either, but I could not repeat them. Which means I still have an eye on this. Most important is, in addition to drag the slider to the right, you need to adjust the max value on the right !!!
This is the main reason for not upgrading hardware or software. You spend hours before you really can start working again ...HarryvL wrote: ↑Fri Aug 10, 2018 9:01 amI am currently completely absorbed by the following: https://forum.freecadweb.org/viewtopic. ... 11#p249338
I thought I was smart ... buy a new and faster computer and do some serious development and computing, but instead since then the opposite happened - no more serious development and computing at all