Adding torque to part for FEM

pandartb3d · Post by **pandartb3d** » Thu Sep 17, 2020 7:16 pm

The right side is fixed and on the left side I have a torque of 2.5 Nm. I can not add a torque to the face so I choose to add two force on two small faces I added. The force is each 125 N (diameter 0.010 m).

: 1.PNG (54.85 KiB) Viewed 1241 times

Is there a better solution to add torque in FreeCAD?

Thank you for your suggestions.

EduBambu · Post by **EduBambu** » Thu Sep 17, 2020 10:05 pm

See the topic;

https://forum.freecadweb.org/viewtopic. ... 08#p420008

There is a discussion with many examples.

Post by **Kunda1** » Thu Sep 17, 2020 10:52 pm

Mod edit: moved to FEM subforum

thschrader · Post by **thschrader** » Fri Sep 18, 2020 7:11 am

pandartb3d wrote: ↑Thu Sep 17, 2020 7:16 pm ...
Is there a better solution to add torque in FreeCAD?

No.
I use the same method...

: strut_connection.JPG (33.32 KiB) Viewed 1175 times

Adding torque to part for FEM

Adding torque to part for FEM

Re: Adding torque to part for FEM

Re: Adding torque to part for FEM

Re: Adding torque to part for FEM