concrete simulation
Moderator: bernd
Forum rules
and Helpful information for the FEM forum
and Helpful information for the FEM forum
Re: concrete simulation
FEM_Concrete may be of interest ...
-
- Veteran
- Posts: 3158
- Joined: Sat May 20, 2017 12:06 pm
- Location: Germany
Re: concrete simulation
Hello,
it is 99% sure that I will have to cut the rebars as shown on the picture.
So the best would be to cut more than needed and create a new lintel.
And I think the new lintel can be put into the wall, set on concrete sole without the necessity to add at the two extremities of the lintel vertical reinforcement like we do when we create a complete new opening into a concrete wall.
it is 99% sure that I will have to cut the rebars as shown on the picture.
So the best would be to cut more than needed and create a new lintel.
And I think the new lintel can be put into the wall, set on concrete sole without the necessity to add at the two extremities of the lintel vertical reinforcement like we do when we create a complete new opening into a concrete wall.
Re: concrete simulation
Cut that 500mm through and put back a UB 300 steel lintel. No concrete simulation.