Surface meshing problem

About the development of the FEM module/workbench.

Moderator: bernd

furki1234
Posts: 7
Joined: Thu Sep 16, 2021 2:54 pm

Re: Surface meshing problem

Post by furki1234 »

NewJoker wrote: Mon Sep 20, 2021 2:48 pm I don't think it's because of the export format, standard STEP should work fine in all cases. Most likely the problem lies in the way the surfaces were modeled in this external software.
While exporting step geometry as a separated geometry and mesh error.
Attachments
Ekran görüntüsü 2021-09-20 18-13-47.png
Ekran görüntüsü 2021-09-20 18-13-47.png (337.86 KiB) Viewed 1248 times
furki1234
Posts: 7
Joined: Thu Sep 16, 2021 2:54 pm

Re: Surface meshing problem

Post by furki1234 »

furki1234 wrote: Mon Sep 20, 2021 3:15 pm
NewJoker wrote: Mon Sep 20, 2021 2:48 pm I don't think it's because of the export format, standard STEP should work fine in all cases. Most likely the problem lies in the way the surfaces were modeled in this external software.
While exporting step geometry as a separated geometry and mesh error.
And with boolean surface tools my results like that.I am aware of the same mistakes but ı could not get it.
Attachments
Ekran görüntüsü 2021-09-20 18-21-15.png
Ekran görüntüsü 2021-09-20 18-21-15.png (382.61 KiB) Viewed 1231 times
furki1234
Posts: 7
Joined: Thu Sep 16, 2021 2:54 pm

Re: Surface meshing problem

Post by furki1234 »

NewJoker wrote: Mon Sep 20, 2021 2:48 pm I don't think it's because of the export format, standard STEP should work fine in all cases. Most likely the problem lies in the way the surfaces were modeled in this external software.
Which software do you think the best suited for surface modeler for freecad?
I am using space claim.
Post Reply