ATM, changing line to be thicker will happen in all situations (plane selection, but also simple origin display). Is that acceptable ? If it isn't, it would need to introduce a mechanism to have hot change depending on the situation.
Great !
Regarding the selectability, why not making the whole planes selectable? As if they were actually solids? This way it's even easier to click and there is no line width issue.
paddle wrote: ↑Fri Jan 21, 2022 10:13 am
Regarding the selectability, why not making the whole planes selectable? As if they were actually solids? This way it's even easier to click and there is no line width issue.
Once again, remember that ATM the viewport representation and selection area is same both in "Select a plane" and "Normal display of origin".
paddle wrote: ↑Fri Jan 21, 2022 10:13 am
Regarding the selectability, why not making the whole planes selectable? As if they were actually solids? This way it's even easier to click and there is no line width issue.
Once again, remember that ATM the viewport representation and selection area is same both in "Select a plane" and "Normal display of origin".
Oh now I understand. I didn't get what you meant by 'simple origin display' as I rarely set it visible.
Then yes I think it's OK to increase the line thickness for both (x5 thickness). And then making the whole plane selectable is not the best.
paddle wrote: ↑Fri Jan 21, 2022 10:29 am
Then yes I think it's OK to increase the line thickness for both (x5 thickness). And then making the whole plane selectable is not the best.
ATM I hardly understand the mean. The thickness of lines is roughly same as the lines in Sketcher, so your problem should be more general than just on the plane selection. Did you try to increase your Pick Radius ?
paddle wrote: ↑Fri Jan 21, 2022 10:29 am
Then yes I think it's OK to increase the line thickness for both (x5 thickness). And then making the whole plane selectable is not the best.
ATM I hardly understand the mean. The thickness of lines is roughly same as the lines in Sketcher, so your problem should be more general than just on the plane selection. Did you try to increase your Pick Radius ?
Hmm I think I should increase my Pick Radius in general indeed.
Though it's more that when you create a new sketch and need to select the plane, the easier it is to select the plane the better. Having to aim precisely at the line is needlesly time-consuming. It would be best if we can just throw the mouse roughly at it and being on it if you see what I mean.
PR is draft now, time to get some answers from community :
* Single click selection is enabled by default. Is it correct or do you prefer it to be disabled ?
* It can be enabled/disabled with a parameter. Is it enough (rare use cases where it has to be changed) or should a preference checkbox be implemented ?
PR is draft now, time to get some answers from community :
* Single click selection is enabled by default. Is it correct or do you prefer it to be disabled ?
* It can be enabled/disabled with a parameter. Is it enough (rare use cases where it has to be changed) or should a preference checkbox be implemented ?