Assembly 3 - Cylindrical Shaft Part run through the oblong hole of another part?

Discussion about the development of the Assembly workbench.
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Post Reply
cyberlacs
Posts: 16
Joined: Sun Aug 05, 2018 3:11 pm

Assembly 3 - Cylindrical Shaft Part run through the oblong hole of another part?

Post by cyberlacs »

Friends I'm developing an assembly with Assembly 3, and I'm needing a Clinand piece to go through the oblong hole of another piece.

Attached image with example of what I want to do.
eixo correr no oblongo.png
eixo correr no oblongo.png (206.7 KiB) Viewed 750 times
I'm waiting

Thank you
cyberlacs
Posts: 16
Joined: Sun Aug 05, 2018 3:11 pm

Re: Assembly 3 - Cylindrical Shaft Part run through the oblong hole of another part?

Post by cyberlacs »

Solution:
1st I selected the YZ plane belonging to the axis of my assembly (orange arrow in the image);
2º I selected the oblong face (red arrow in the image)
3º I selected the Point Plane Distance option and put in property a distance so that the axis is in the center of the oblong;
solution.png
solution.png (170.03 KiB) Viewed 738 times
Use Move Part and work perfectly
Post Reply