Making planes visible in assembly?

Deadhorse · Post by **Deadhorse** » Thu Dec 20, 2018 4:42 pm

Is there a way to make datum planes, original or user created, visible in assembly mode/work bench?

kbwbe · Post by **kbwbe** » Thu Dec 20, 2018 5:08 pm

Deadhorse wrote: ↑Thu Dec 20, 2018 4:42 pm Is there a way to make datum planes, original or user created, visible in assembly mode/work bench?

Not possible. They are filtered out during import, as they would not work correctly.

dan-miel · Post by **dan-miel** » Thu Dec 20, 2018 8:31 pm

A possible work around. The first part put into to assembly seems to be inserted at global xyz. I have a "template" with surfaces at xyz so I can tell where it is. Then work off of that corner of your part. You could put in a dummy part and hide it.
Dan

triplus · Post by **triplus** » Fri Dec 21, 2018 11:10 am

Deadhorse wrote: ↑Thu Dec 20, 2018 4:42 pm Is there a way to make datum planes, original or user created, visible in assembly mode/work bench?

ATM only Assembly 3:

https://forum.freecadweb.org/viewtopic. ... 85#p203685

Making planes visible in assembly?

Making planes visible in assembly?

Re: Making planes visible in assembly?

Re: Making planes visible in assembly?

Re: Making planes visible in assembly?