Engine running with A2Plus

[dcapeletti]

Hello,
I just saw this example using Assembly 4. It's an engine assembled and running.

https://forum.freecadweb.org/viewtopic. ... 06#p293179

Since the design files are available in the ASM 4 repository, it wouldn't take too long to do the assembly. You only need to design the crankshaft, make an assembly and make a script to move the crankshaft which moves the whole assembly.

Is anyone encouraged to do so?
I'll try it in my free time. I listen to suggestions or recommendations.

Thanks

[dcapeletti]

I made the engine and the assembly with A2Plus. The camshaft is still to be finished. You can see the GIF to see the animation in operation.

https://gitlab.com/dcapeletti/ejercicio ... A2Plus.gif

Repository with all parts
https://gitlab.com/dcapeletti/ejercicio ... %20tiempos

[roerich_64]

Thumbs up! Awesome

[dcapeletti]

Thank you very much.

What I'm trying to do is make the animation run a little faster. In a thread I was recommended to deactivate the following lines https://forum.freecadweb.org/viewtopic. ... on#p264362 and it has worked, but it is still a bit slow.

My animation code is as follows https://gitlab.com/dcapeletti/ejercicio ... /README.md

Greetings

[kbwbe]

What I'm trying to do is make the animation run a little faster. In a thread I was recommended to deactivate the following lines

Hi Diego,
good work !

A2plus is not really a simulation WB, as it's solver is python based ATM. Therefore it can not compare with solvers written in C.
Perhaps this will come in future.

Greetings, Klaus