with the Fasteners Workbench, my procedure for fasteners is as follows:
- Enter Fastener Workbench and enable "Match crew by outer thread diameter (pass hole)".
- Select all hole edges
- Create washers (correct diameter is determined automatically).
- Select all washers (upper) hole edges
- Create screws (correct diameter is determined automatically).
- Select all screws and set appropriate length.
- Create coordinate axes for all holes.
- Select the Assembly 4 model and create a washer, setting the type and diameter in the dialog.
- Place the washer. Select the body and the axis in the dialog.
- Do this six times (you can't do more than one at a time).
- Select the Assembly 4 model and create a screw, setting the screw type, diameter and length in the dialog.
- Place the screw. Select the body and the axis in the dialog. Know how thick the washer is, because this value must be entered as z-offset.
- Do this six times (several at once is not possible).
Can this be done better?
What one would actually like, would be: To these 6 holes, add ISO 14583 screws with ISO 7089 washers in correct diameter with 10mm length.
This is a duplicate from german forum https://forum.freecadweb.org/viewtopic. ... 13&t=59171