Hello.
In this example I have a base plate with a 25mm dia hole, and a bearing block on top. I select the hole edge and the bearing inner edge and apply a constraint - either axis-axis or point-point. Each time the base plate moves (with respect to it's sketch) and the bearing stays put. If I set the bearing to fixed position = false then the constraint fails with "The highlighted parts were not moved. they are not constrained to a fixed part!"
How can I make the bearing move instead?
TIA. Kel.
A2plus constraint - which part has dominance?
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
- babaroga
- Posts: 180
- Joined: Sun Aug 14, 2016 6:52 pm
- Location: Banja Luka, Republic of Srpska, Bosnia and Herzegovina
Re: A2plus constraint - which part has dominance?
Make base plate fixed...
Re: A2plus constraint - which part has dominance?
Moved to Assembly forum.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.