Manual -- skipping heading levels?

Discussions about the wiki documentation of FreeCAD and its translation.
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Post Reply
garya
Posts: 405
Joined: Tue Nov 20, 2018 1:00 am
Location: Ovando, MT, USA

Manual -- skipping heading levels?

Post by garya »

The current first few manual pages skip heading levels, starting at level three instead of level two. Is this intentional, or an oversight or historical artifact which should be corrected?

I'm asking because in expanding "The FreeCAD Interface" I end up with four levels of bullets which is crazy; using additional heading sublevels would improve things. Seems like moving the current level 3 up to level 2 would be advised.
Post Reply