In sheetmetal, we can select multiple faces. During first iteration[orange face], My Second Selected Face[green face] size changes as shown below than base Object. Any method Available to find reduced sized face from current Object [During loop].
Find a Face inside Selected Face
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
-
- Posts: 384
- Joined: Sat Sep 24, 2016 6:51 am
- DeepSOIC
- Veteran
- Posts: 7896
- Joined: Fri Aug 29, 2014 12:45 am
- Location: used to be Saint-Petersburg, Russia
Re: Find a Face inside Selected Face
I'm afraid, you have to interface to sheetmetal geometry algorithm to figure that out. It's toponaming stuff.
sheetmetal is maintained by shaise, afaik geometry engine is by ulrich1a.
sheetmetal is maintained by shaise, afaik geometry engine is by ulrich1a.
ulrich1a wrote:ping
shaise wrote: