arch roof tool - geometry errors

[rockn]

Hi Jim,
It's because of conterclockwise direction. Cf : Arch_Roof #How_to_use
In Sketch002_br to tl geometry are clockwise direction.

[JLB85FR]

Hi Rockn
nice for BOPCheck !

To make a one pane roof, make wire with 4 edges, create a roof, set 3 panes with an angle of 90°.

I think that I already tried to set 3 panes with 90 degrees angle, but I had problems it had abnormal behavior, but at this time I just changed these properties in 2 designs were they were not correct and it works fine.
I don't understand why it was not working, now all is ok...
thanks for the tip anyway.

[NormandC]

If I create a rectangle in a sketch, it would seem that you must start at the bottom left corner and drag to the top right, if you go from top right down to bottom left you get a plane normal in the wrong direction

Now why would you do that, is that normal for down unders?

[jmaustpc]

If I create a rectangle in a sketch, it would seem that you must start at the bottom left corner and drag to the top right, if you go from top right down to bottom left you get a plane normal in the wrong direction

Now why would you do that, is that normal for down unders?

Of course, perfectly normal down here in upside down tomorrow land! Should seem normal to you to, being a weird "cacky handed" "lefty"