Hi Jim,
It's because of conterclockwise direction. Cf : Arch_Roof #How_to_use
In Sketch002_br to tl geometry are clockwise direction.
arch roof tool - geometry errors
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
Re: arch roof tool - geometry errors
Formations - Assistance - Développement : https://freecad-france.com
Re: arch roof tool - geometry errors
Hi Rockn
nice for BOPCheck !
I don't understand why it was not working, now all is ok...
thanks for the tip anyway.
nice for BOPCheck !
I think that I already tried to set 3 panes with 90 degrees angle, but I had problems it had abnormal behavior, but at this time I just changed these properties in 2 designs were they were not correct and it works fine.rockn wrote:To make a one pane roof, make wire with 4 edges, create a roof, set 3 panes with an angle of 90°.
I don't understand why it was not working, now all is ok...
thanks for the tip anyway.
Re: arch roof tool - geometry errors
Now why would you do that, is that normal for down unders?jmaustpc wrote:If I create a rectangle in a sketch, it would seem that you must start at the bottom left corner and drag to the top right, if you go from top right down to bottom left you get a plane normal in the wrong direction
Re: arch roof tool - geometry errors
Of course, perfectly normal down here in upside down tomorrow land! Should seem normal to you to, being a weird "cacky handed" "lefty"NormandC wrote:Now why would you do that, is that normal for down unders?jmaustpc wrote:If I create a rectangle in a sketch, it would seem that you must start at the bottom left corner and drag to the top right, if you go from top right down to bottom left you get a plane normal in the wrong direction