[PR] [Discussion] - 'Multi-Width' Arch Wall & Stair Landing ( and Profile/ Face / Extrusion Generator )

A forum dedicated to the Draft, Arch and BIM workbenches development.
paullee
Posts: 1588
Joined: Wed May 04, 2016 3:58 pm

Re: [PR] [Discussion] - 'Multi-Width' Arch Wall & Stair Landing ( and Profile/ Face / Extrusion Generator )

Postby paullee » Mon Jul 01, 2019 1:48 am

A 'Side-Effect' when 2 consecutive edges are parallel... a bug in fact

Or peoples want 'starting width' and 'ending width' - would be difficult to define where exactly should these parameters measure ?

Screenshot from 2019-07-01 09-41-18.png
Screenshot from 2019-07-01 09-41-18.png (186.31 KiB) Viewed 103 times
Screenshot from 2019-07-01 09-43-03.png
Screenshot from 2019-07-01 09-43-03.png (180 KiB) Viewed 103 times
Attachments
Test_ ArchWall_ Various Width_ 4.FCStd
(9.15 KiB) Downloaded 3 times
paullee
Posts: 1588
Joined: Wed May 04, 2016 3:58 pm

Re: [PR] [Discussion] - 'Multi-Width' Arch Wall & Stair Landing ( and Profile/ Face / Extrusion Generator )

Postby paullee » Tue Jul 09, 2019 7:06 pm

Fixed, if this feature is useful to anyone.
Screenshot from 2019-07-10 02-44-37.png
Screenshot from 2019-07-10 02-44-37.png (140.23 KiB) Viewed 52 times
Screenshot from 2019-07-10 02-48-54.png
Screenshot from 2019-07-10 02-48-54.png (154.4 KiB) Viewed 52 times
Attachments
ArchWall.py
(49.7 KiB) Downloaded 2 times
DraftGeomUtils.py
(112.39 KiB) Downloaded 2 times
Test_ ArchWall_ Various Width_ 4a.FCStd
(9.43 KiB) Downloaded 2 times