Yes hopefully these could be automated
Do you find the mapping of steps 'proportionally' - so each tread width is as expected ?
How about in comparison the behaviour of the original Macro in OP ? Thanks.
Yes hopefully these could be automated
On linear path segments steps are mapped proportionally, but not on curved
Although I tried a lot of combinations (alignment: left/rigt, inner path/outer path) I'm not able to build my last stair with the original Macro
Hmmm, studied your model, really no idea the algorithm / logic behind MapSketchOnSurface
Yes, Chris_G kindly pointed out to me how to manage a non-deformed mapping of the stair profile onto a general curved surface.
Thanks! @Chris_G 'slightly' elaborated the algorithm of MapSketchOnSurface which is way far too difficult for mebalrobs wrote: ↑Fri Jan 28, 2022 2:44 pm Yes, Chris_G kindly pointed out to me how to manage a non-deformed mapping of the stair profile onto a general curved surface.
This way I can control the layout of the steps with sketches, but at the cost of increasing workload and some inaccuracies due to the discretisation.
Impressive, almost four times as fast!