Roy_043 wrote: ↑Fri Jun 18, 2021 10:57 am
bernd wrote: ↑Fri Jun 18, 2021 10:08 am
open the file from the last post, use the Draft move tool ...
Moving an object that is attached does not make a lot of sense...
To avoid cyclic dependencies and the TNP you should attach the "holes" sketch to the base of the wall, not to a face of the wall.
This is quite cools. I learnt there is a symmetric extrusion. Never knew there is
. Very useful. In the wall "Move with host" needs to be active. Afterwards moving and rotating of the wall is possible and the holes will come with the wall. The tree looks clean too.
Just one point, would it be possible to give a step by step how to attach the sketch to the trace even if the trace is in a angle direction?
One disadvantage. If the wall is make visible the sketch is not anymore. To have both only woks for me in wire mode.