angle(%)=100 x rise/run = 100 tg(angle(degree))
SlopedPlanesMacro
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
Re: SlopedPlanesMacro
Yes
Re: SlopedPlanesMacro
And now FreeCAD supports
Angle
"deg" 1.0; // degree (internal standard angle)
"rad" 180/M_PI; // radian
"gon" 360.0/400.0;// gon
Re: SlopedPlanesMacro
and the available schemas are
Re: SlopedPlanesMacro
The infinite representation (90º) is a serious problem. Probably this is the reason because this unit is not available in FreeCAD.
Very interesting question. Thank you.
Very interesting question. Thank you.
Re: SlopedPlanesMacro
Good morning
We can do a little experiment and include a slope (%) after the height(rise)/run, in advenced options ATM these controls, height and run, are not working perfectly.
- markko martin
- Posts: 64
- Joined: Tue Aug 09, 2016 5:51 pm
- Location: Italy
Re: SlopedPlanesMacro
Yes this is a good thing include a slope (%).
At worst if input slope creates bugs maybe we can only show the slope % ( freecad calculate tan of input angle degrees) .
I don't Know if it's possible....
Loris
Re: SlopedPlanesMacro
It could be
EDIT: it isn't finished. There are some things to fixe
- markko martin
- Posts: 64
- Joined: Tue Aug 09, 2016 5:51 pm
- Location: Italy
Re: SlopedPlanesMacro
Hi
a proposal for the sweep
The templates for the version two or three
a proposal for the sweep
The templates for the version two or three
Re: SlopedPlanesMacro
Hello,
thank you for your work with this macro.
would it be possibke to add it to the addon manager ?
thank you for your work with this macro.
would it be possibke to add it to the addon manager ?